CSUSA Ligero Pen

Signed-In Members Don't See This Ad
Status
Not open for further replies.

Yarael

Member
Joined
Aug 8, 2006
Messages
107
Location
Lubbock, TX, USA.
Anyone ever done one of these. I was drilling the blanks. Got to the one for 17/32 tube. Drilled it actually as 1/2 inch. Tried to put the tube in didnt go in at all. Which technically 1/2 inch is larger than 17/32 by 1/32. Even tried another 1/2 inch bit to drill after nothing but dust just a tad bit bigger hole. Still the tube didnt go in. So went and got a 9/16 bit which I havent had time to try yet. But so far from my experience the instructions so far at least for drilling are way off on the size for the upper tube. Or do I need the 17/32 bit from CSUSA to do this? Or are the insturctions just that far off??
 
Signed-In Members Don't See This Ad

Yarael

Member
Joined
Aug 8, 2006
Messages
107
Location
Lubbock, TX, USA.
Doh was thinking other way around. NM. Been a very very long week. Math no longer working at all. Cant even add 2+2 anymore been that bad.
 

scasey88

Member
Joined
Mar 16, 2006
Messages
18
Location
Sparks, Nevada.
I just turned a Lotus pen and realized I didnt have a bit that would
fit the larger tube and I used a 9/16 bit, there was some play in there, but i used some Gorilla Glue to fill the gap and it worked fine.
 
Status
Not open for further replies.
Top Bottom