Corian Question

[dabeeler]

I am wanting to try segmenting some corian pieces. What would be a good method to obtain flat sides for gluing?

Thanks,
David

 

[mick]

Table saw with an 80 tooth blade....no sanding required!

 

[kirkfranks]

Same thing different direction. I use miter saw with 80 tooth blade....no sanding required either.[]

 

[rhahnfl]

What do you glue with? CA? Thin or thick? I've got a bunch of corian to play with... when I get the shop set up.

 

[Snazzypens]

I segmented with corian just using the fine blade on my bandsaw. I then glued up with CA thick. Very happy with my pen
Toni

 

[rd_ab_penman]

Originally posted by dabeeler
<br />I am wanting to try segmenting some corian pieces. What would be a good method to obtain flat sides for gluing?

Thanks,
David

Hi David! I use my little 11' bandsaw with fence. I use Med CA.

<br />

Les in Alberta

<br />
"What's YOUR Carbon Footprint?"

 

[Snazzypens]

Les that is one heck of a fence you got there
bye Toni

 

[barrels]

David,

Obviously you could use either a band saw, table or miter saw to acomplish the components to assemble. I use a table saw with a sled that locks in the blank and remember the pieces are prety small and try to keep them square when glueing or possilble trouble when drilling and consider the way you will keep it all together when drilling, if i am not careful th parts separate. I use thick CA and rough the pieces slightly for bonding.

 

[dabeeler]

Thanks for the feedback. It sure helps.

David