Corian help

[dullbroadhead]

What type of glue do you use for corian?
I have used epoxy but after turning can see the line in spots, and can feel it with my finger nail.

Thanks

Bob

 

[Displaced Canadian]

I use CA.

 

[seawolf]

I sand lightly with 1000 grit wet dry then use thin CA. I can't find the seam after turning.
Mark

 

[jkeithrussell]

Sounds more like the surfaces weren't flat/square than a problem with the glue. Medium or thick CA work fine. Epoxy is thicker than I would like for this purpose.

 

[rjwolfe3]

I use CA with no problems so far.

 

[workinforwood]

I use gorilla glue and clamp the pieces tight together.

 

[THarvey]

I use medium CA.

I clean the pieces with acetone, sand lightly the glue.

 

[alamocdc]

CA for me too.

 

[nava1uni]

I use medium CA.

I clean the pieces with acetone, sand lightly the glue.

I do the same, but I also clamp the piece and leave them for a few hours before I cut or turn them. I don't get lines until I am segmenting.

 

[dullbroadhead]

Thanks!

Guess it is time to try a different glue.

Bob

 

[KenV]

Excellent article by Kurt is at

http://kurthertzog.com/demos.htm

working with corian is the title.

Take a few minutes and look through the rest of the list --- some really good content there.