carabetec mini lathe

[jbyrd24]

I have been using a carbated mini lather for quite awhile now.
When I turn antler the lathe tends to walk quite abit. I have
been looking into getting a jet lathe. I was thinking they carry
a little heavier midi lathe but can't find it. What lathe would
you folks suggest. Thanks for any suggestions.

 

[Randy_]

About 10 cents worth of deck screws will solve your problem. Drive a screw through each foot into your bench. If you need to move the lathe it takes all of 30 seconds to remove the screws. I do this with my JET mini and it works just fine!!!

 

[jwoodwright]

Your problem is the carb. Sounds like a rough idle adjustment...

The Jet is fuel injected, runs much smoother than a carb...[][][}]

 

[wdcav1952]

Originally posted by jwoodwright
<br />Your problem is the carb. Sounds like a rough idle adjustment...

The Jet is fuel injected, runs much smoother than a carb...[][][}]

It also helps to get a can of Prop Wash and spray the carb.
[] [}] []

 

[Rifleman1776]

Yer all wrong. The deer just ain't dead yet. [:0][]

 

[jbyrd24]

All right guys I catch your drift. LOL [][}][:I]
Sounds like a couple of bolts should do the trick.

Thanks...........Have a great Saturday !

 

[Old Griz]

Nah... I think Bryan is smart enough to make sure the deer was dead first... but don't know if he knew to take the antlers off the head first... [}][}]

 

[Ligget]

LOL[][]

 

[jbyrd24]

Darn........I knew I had forgotten something ![]

 

[jbyrd24]

[][}]Shouldn't you guys be out mowing the yard or[] doing a few
"honey dews" today. I think I better be telling your
better halfs.[]

 

[jbyrd24]

I hope you guys doooooooooooooo know I'm kidding.[]