lrawlins
Member
I was given a large aluminum heat sink that was 6" square and just over 3" high.
After cutting it down to fit a 1" wide silicone mold I mixed up Art & Glow resin and then mixed in 3 or 4 colors of Pearl Ex and filled the gaps.
Drilling and turning were a bit tricky as any heat build up loosened the resin and it came apart more than once. The next one I will go even slower on the drilling and turning so I don't have to put it back together.
This is the results.
After cutting it down to fit a 1" wide silicone mold I mixed up Art & Glow resin and then mixed in 3 or 4 colors of Pearl Ex and filled the gaps.
Drilling and turning were a bit tricky as any heat build up loosened the resin and it came apart more than once. The next one I will go even slower on the drilling and turning so I don't have to put it back together.
This is the results.