Adjustable Pen Mandrel

[bosipipes]

I am not at home at this time and was hoping that someone might be able to help me. I need to know what the Diameter of the CSusa Adjustable Pen Mandrel is. I think my rod is bent alittle.
if you have this item at home can you post the #'s for me.
Thanks.

 

[rherrell]

I'm assuming you have the "A" mandrel which is made from the letter"D" drill rod. The diameter is .246.

 

[bosipipes]

Thanks Rick.
All it says's on their wed site is the it fits all the bushings that they sell.
So would the "A" mandrel correct?

 

[rherrell]

They sell both A and B bushings. If it fits a slimline bushing it's an A mandrel.

 

[Rifleman1776]

CS is 'A'.

 

[bosipipes]

Thank you Frank.
You wouldn't happen to know the thread cut would you?

 

[rherrell]

If you have the brass nut it should be 1/4"-28...SAE fine threads.

 

[bosipipes]

Thanks rick

 

[loglugger]

I think it is Johnnycnc that has some very nice tight fitting mandrels that will be a good fit for you.
Bob

 

[jcollazo]

CSUSA is "A" rod only. I sell these in various lengths on my website.

 

[loglugger]

Sorry Joe I guess I had a brain fart again.
Bob