Purpleheart with Spalted Tamerind Celtic Knot and Marblewood Grip
- Thread starter Buddy Stacy
- Start date
Signed-In Members Don't See This Ad
Signed-In Members Don't See This Ad
jttheclockman
Member
Looks good. What did you make the cuts on?? Looks very thin, was it the bandsaw??
DJBPenmaker
Member
Buddy Stacy
Member
Yes, my bandsaw. Found it much easier to use than my table saw for the knots.
Sent from my iPhone using Penturners.org mobile app
Buddy Stacy
Member
I actually wondered about using veneer when I saw how thin the Tamerind was gonna be.
Sent from my iPhone using Penturners.org mobile app
OZturner
Member
Excellent Pen, Buddy.
Nice Celtic Knot, Though I would have preferred it to be on the Lower Blank, where it could be Seen Better, I feel it is a shame that the Clip Interferes with an Uninterrupted View of the Knot.
Great Fit and Excellent Finish.
Congratulations,
Brian.
Nice Celtic Knot, Though I would have preferred it to be on the Lower Blank, where it could be Seen Better, I feel it is a shame that the Clip Interferes with an Uninterrupted View of the Knot.
Great Fit and Excellent Finish.
Congratulations,
Brian.
Buddy Stacy
Member
LOL, it was actually meant to be that way. The whole reason there is a marblewood grip is because I glued the short tube into the long blank by mistake. The only way I could think to fix it was to add the grip, but then the knot had to be on the upper blank rather than on the lower like I wanted it to be.