My mistake Pen

Signed-In Members Don't See This Ad
See more from Barnyard

Status
Not open for further replies.

Barnyard

Member
Joined
Nov 6, 2006
Messages
7
Location
Calgary, Canada.
This is a Flat top Rollerball that I had problems with the brass tube. I had cut a chunk out of the brass tube while I was cutting the space for the center piece. I cut it a bit shorter but it doesnt seem to show much.
 
Signed-In Members Don't See This Ad
Joined
Sep 24, 2006
Messages
8,206
Location
Tellico Plains, Tennessee, USA.
Nice chikin'.. pen's not bad either. [}:)]
Is this one of those kits you have to notch the cap so the clip will be below the end of the kit... they are a pain for me.. don't see anything wrong with yours..
 

Barnyard

Member
Joined
Nov 6, 2006
Messages
7
Location
Calgary, Canada.
Well the chicken in the background is actually a stove cover I think I picked them up at Home Outfitters for about 4 bucks if ya would like some[:D]. Im not only new to turning but photography as well so I posted a second pick to try and get a better look at the grain.


Oh and yes this kit makes you cut out a notch of about 1/8 of an inch on the threaded part of the cap and thats where I ran into trouble.
 
Status
Not open for further replies.
Top Bottom