darrin1200
Member
I have been facinated by the 360 Herringbone. I finally got up the nerve to try one.
It is African Blackwood and Babinga dressed in a BT/TG Elegant Beauty Click.
My mother in law has always supported me in all my endevours, so I figure my first complex segment would be an appropriate gift.
I planed the wood down to 1/2" blanks, then cut 1/8" thick slices on the bandsaw. I used a small sled attached to the mitre guage.
It took me a little while to figure out how the pieces glue together. It was hard to wrap my brain around the layout.
I made a few mistakes gluing up. Some places not quite square which left small voids in the glue seams.
A lot of work is still needed, but I can't wait to try another.
All comments and critiques welcome.
Darrin
It is African Blackwood and Babinga dressed in a BT/TG Elegant Beauty Click.
My mother in law has always supported me in all my endevours, so I figure my first complex segment would be an appropriate gift.
I planed the wood down to 1/2" blanks, then cut 1/8" thick slices on the bandsaw. I used a small sled attached to the mitre guage.
It took me a little while to figure out how the pieces glue together. It was hard to wrap my brain around the layout.
I made a few mistakes gluing up. Some places not quite square which left small voids in the glue seams.
A lot of work is still needed, but I can't wait to try another.
All comments and critiques welcome.
Darrin