Island Happy Navigator

Signed-In Members Don't See This Ad
See more from THarvey

THarvey

THarvey

Member
Joined
Oct 4, 2007
Messages
2,087
Location
Anniston, AL, USA
Eugene (ElMostro) appropriately named these blanks "Cancun". They remind me of the island.

Spalted Maple Burl Cancun wrapped around a Chrome Navigator. Four views of the same pen.

Thanks for looking.
 

Attachments

  • Navigator Chrome - Maple Burl Cancun - 1.jpg
    Navigator Chrome - Maple Burl Cancun - 1.jpg
    39.5 KB · Views: 244
  • Navigator Chrome - Maple Burl Cancun - 2.jpg
    Navigator Chrome - Maple Burl Cancun - 2.jpg
    20.4 KB · Views: 186
  • Navigator Chrome - Maple Burl Cancun - 3.jpg
    Navigator Chrome - Maple Burl Cancun - 3.jpg
    20.8 KB · Views: 226
  • Navigator Chrome - Maple Burl Cancun - 4.jpg
    Navigator Chrome - Maple Burl Cancun - 4.jpg
    20.6 KB · Views: 197
Signed-In Members Don't See This Ad
THarvey

THarvey

Member
Joined
Oct 4, 2007
Messages
2,087
Location
Anniston, AL, USA
jasontg99 said:
Very cool. How did you finish these? I have some coming in the mail and I was wondering how I am going to finish them.
Click to expand...


First, I recommend you turn these with a scary sharp skew.

Here is what I did with this one:

1. Dry sanded to 2000 (started at 600).
2. Wiped down blanks with slightly damp cloth, spin to air dry.
3. Applied two coats of medium CA (I was out of thin, or I would have used three or four coats of thin).
4. Wet sanded to 12000 MicroMesh.
5. Two coats of McQuires Plastix Polish. (Let each coat dry before buffing off with a cotton cloth.)

Be careful to avoid heat, from drilling to finishing. The wood and resin will react differently.

Have fun.
 
Last edited:
jasontg99

jasontg99

Member
Joined
Feb 21, 2009
Messages
1,597
Location
Portsmouth, Virginia
Tim,

Thanks for taking the time to explain your finish. What speed did you drill at? Normally I drill acrylics at 600 and wood at 1500. I will post my results when I am done with my attempt. Hopefully it turns out as nice as yours.

Thanks,
Jason
 
THarvey

THarvey

Member
Joined
Oct 4, 2007
Messages
2,087
Location
Anniston, AL, USA
jasontg99 said:
Tim,

Thanks for taking the time to explain your finish. What speed did you drill at? Normally I drill acrylics at 600 and wood at 1500. I will post my results when I am done with my attempt. Hopefully it turns out as nice as yours.

Thanks,
Jason
Click to expand...


Ran down and checked drill press... It is setup at 640.
 
THarvey

THarvey

Member
Joined
Oct 4, 2007
Messages
2,087
Location
Anniston, AL, USA
jasontg99 said:
Tim,

Thanks again. I was a little nervous about drilling/turning these. I was especially curious about a CA finish on the acrylic portion.
Click to expand...


I was too.

I remember seeing a post about finishing these a few months ago. I do not remember who it was, or I would give them credit. The thing I remembered was:

"Drill like acrylic. Finish like wood."

Good luck. Looking forward to seeing your creation.
 
You must log in or register to reply here.
Previous Next
Top Bottom