Charlie_W
Member
Here are a couple of pens I had done a while back but never posted.
The first is is a Wall Street II with an italian resin blue blank. I think I received the blank in a swap. I found out that these resins have a low melting point especially when drilling! All went well till it was wet sanded, polished and buffed. I found a shady/cloudy area on one end. To save the blank, I parted off that area and glued on a piece of blank acrylic, turned and finished again.
I really like the depth of the resin!
The second is a CS USA clicker with a Brooks blank. The customer wanted a pen and some bottle stoppers in the University of Michigan colors.
Jonathon did a great job and the customer was happy. This clicker was made with one of the extra blanks I ordered.
The first is is a Wall Street II with an italian resin blue blank. I think I received the blank in a swap. I found out that these resins have a low melting point especially when drilling! All went well till it was wet sanded, polished and buffed. I found a shady/cloudy area on one end. To save the blank, I parted off that area and glued on a piece of blank acrylic, turned and finished again.
I really like the depth of the resin!
The second is a CS USA clicker with a Brooks blank. The customer wanted a pen and some bottle stoppers in the University of Michigan colors.
Jonathon did a great job and the customer was happy. This clicker was made with one of the extra blanks I ordered.