finish trouble

[firewhatfire]

the three on the right have a haze to them. The guy at WC says it is moisture as I clean them with denatured alcohol and used CA to quickly. What do yall think and as well any other comments are welcome? This is requested style and I have alot more of them to do if Ican figure this out. Will whatever the moisture is soak back in or evaporate or is it there forever?

 

[Drstrangefart]

If you use accellerator, wait a bit longer before spraying and hold the can about 18 inches away.

 

[firewhatfire]

It doesn't seem to be a universal problem but that could be a consideration. At this point anything is possible. He told me to change to acetone to clean(I think) will try it for the next few.

 

[S.A.Mappin]

When I use denatured alcohol to clean after sanding, I allow the blanks to dry.

Next time don't saturate them too much, and allow them to dry, and you'll be just fine. Getting in a hurry to apply a finish is not always going to give you good results.

Other than that, they look good!