Curly Angle Cut Bubinga

Signed-In Members Don't See This Ad
See more from vick

Status
Not open for further replies.

vick

Member
Joined
Nov 16, 2004
Messages
1,447
Location
Gilbert, AZ, USA.
I found a real nice board of Curly Bubinga and a local hardwood store and got a good price on almost 3 BF. So far I just cut a few blanks so that I could decide how to cut the rest. This one was cut at about a 30 degree angle and I think it looks nice but I had some trouble turning it.
I think the finish turned out well it is CA that has been micromeshed and I finally tried Tom's suggestion of using McGuires anti swirl for a final polishing.

Comments, critiques and suggestions always welcome.


20059783113_CurlyBubigna.jpg
 
Status
Not open for further replies.
Top Bottom