CSUSA Sketch Pencil - Segmented myPR

[Jeff-in-Indiana]

I thought this CSUSA Sketch Pencil came out fairly good.

• Homemade polyresin blank : "My Molten Metal" [the wife likes to name the color-combos]
• Segmented to give it a different look
• Micromeshed to 12,000 followed by swirl remover

 

[NavyDiver]

Nice job on the blank and the pencil!

 

[JDPens]

Ditto! That is an awesome blank. []

 

[stevers]

Very nice finish, but I don't see the segmentation. Am I missing something? Otherwise I like it. I've been wanting to try a sketch pencil.

 

[Jeff-in-Indiana]

Yes, Stevers, the segmentation is not the most obvious ... the section near the clip, SHOULD have been in the middle .. there are three equal section all rotated 90 degrees from each other, but had I been able to tell that the middle and nib section were going to be so similar, I would have exchanged the clips section with the middle section ... (I just photoshopped the pen to reflect that, and I was unhappy with the result, notice I did not post the pic [8D])

thanks to everyone for the comments ... next time I segment, I will make sure there is Drama! []

 

[BigRob777]

Molten metal? I'd call it seaweed, as it looks like swirling seaweed in the ocean tide.
Cool pencil.
Rob

 

[bob393]

Quite nice!