Copper Retro Rollerball

Signed-In Members Don't See This Ad
See more from penfancy

penfancy

Member
Joined
Jun 7, 2010
Messages
180
Location
Houston,TX
I hadn't been in the shop too much lately. I had a chance last night. I tried some new techniques that I read about in the Pen Turning forum, skew from start to finish. It wasn't so nice to go straight to MM. I had to start at 320 just to smooth things out a bit. Went to 600 wet then plastic polish.
 
Signed-In Members Don't See This Ad

penfancy

Member
Joined
Jun 7, 2010
Messages
180
Location
Houston,TX
THanks, Mark. I ordered it from CSUSA. I think it was in their clearance section. "Copper Fire" might have been the name.
 
Top Bottom