BOW Cigar

Signed-In Members Don't See This Ad
See more from Gagler

Gagler

Member
Joined
Jun 16, 2008
Messages
272
Location
Bellaire, TX, USA.
Here is one I finished up this morning. It is Bethlehem olive wood on a cigar kit - I figured I needed to finish it today as I am using it to help me write a speech I have to give at church tomorrow (for those who went to Texas University, that's an indirect reference of how I'm looking for some Divine inspiration).

As usual, my photography is bad - the knot hole on the upper portion came pretty close to blowing out and took what seemed like a gallon of CA glue and fine sawdust from this pen (I rarely drink coffee so didn't have any grounds to use).

You also can't tell too much with the picture, but I think I also have this BLO / CA glue finishing technique down after a few more than I care to count failures. Thanks to all who have sent me tips, suggestions, etc. as I used a little bit of everyone's advice over the last dozen or so!

Have a good rest of the weekend-

Michael
 

Attachments

  • bow082008a.jpg
    bow082008a.jpg
    91.7 KB · Views: 215
  • bow082008b.jpg
    bow082008b.jpg
    95.9 KB · Views: 148
Signed-In Members Don't See This Ad

Gagler

Member
Joined
Jun 16, 2008
Messages
272
Location
Bellaire, TX, USA.
Thanks!

I appreciate all of the comments, the BOW is really a nice wood.

The pen certainly helped in the preparation of the speech, so the Divine Inspiration came through. Then again, they weren't my words to begin with!
 
Top Bottom