Antler~N~Acrylic

[Janster]

With the weather warming a bit I made it to the workshop, AKA, garage. I am in the process of two antler based pens with AA segments. One is quite simple and the other too, except for the decal work I am going to incorporate into it. They will both be finished w/Mylands products. I used Smitty's Component kits and also upgraded both with Schmidt roller ball refills. I took this picture w/my cell phone as it was a bit chilly when I finished the first one, shown below. Be well.......Jan

 

[SDB777]

I've always wondered about the Mylands being used as a finish for PR....does it leave scratches that can be felt(cause I think I can 'see' some in the photo)? Then again, everything shows up against black PR...

Nicely fit to the components!!!




Scott (I run from black PR on its own) B

 

[Janster]

it is the photo, the "finial" is factory and it looks the same!