6 sided cigar

Signed-In Members Don't See This Ad
See more from dscott

Status
Not open for further replies.

dscott

Member
Joined
Apr 4, 2005
Messages
200
Location
Cleveland, Tennessee, USA.
Pic dont do it justice could not have done it without my buddy Chris

200553022523_6.jpg
 
Signed-In Members Don't See This Ad

woodscavenger

Member
Joined
Jan 16, 2005
Messages
1,491
Location
Boise, ID, USA.
I like this one as well. I remember seeing a discussion about making a little jig to hold the mandrel with a home built indexing wheel on one end that you could customze to the number of side you wanted. Then you ran the thing across a router table, re-indexed and repeated until all sides were cut......
 

Fleabit

Member
Joined
Jan 16, 2005
Messages
1,271
Location
Hertford, NC, USA.
Nice job. Been looking at an ornamental mill myself. Just havnt forked over the cash. I would look at hand wiping poly or sraying poly or laquer on it.
 
Status
Not open for further replies.
Top Bottom