International Association of Penturners - View Single Post - Segmenting questions
View Single Post
Old 11-08-2018, 07:18 AM   #2 (permalink)
mark james
 
mark james's Avatar
 
Join Date: Sep 2012
Location: Medina, Ohio
Posts: 6,864
Photos: 461

Default

Hi Jake, I have cut thin slices on a Craftsman Table Saw, a Bosch Contractors Table Saw and a Byrnes Model Makers Table saw. Each, can work - how you construct your sleds will be important. Zero tolerance inserts are also important depending on the sizes of your pieces.

These are just a few thoughts to get you started. I know others will chime in and will have excellent suggestions. Many ways to get to the same result, and knowing how to use what you have available is vital for safety.
Attached Thumbnails
img_2920.jpg   img_2922.jpg   img_3517.jpg   img_0697.jpg   img_3518.jpg  

__________________
Check out the
IAP Collection

The IAP Collection is a permanent collection of pens
that has been established from the
IAP Membership explicitly for the purpose of
public display, preservation and inspiration.
mark james is offline   Reply With Quote Top