International Association of Penturners - View Single Post - Cleaning Grease off New Lathe Bed
View Single Post
Old 11-05-2018, 08:06 PM   #1 (permalink)
NewfoundlandLaw
 
NewfoundlandLaw's Avatar
 
Join Date: Oct 2018
Location: Newfoundland
Posts: 70
Photos: 0

Default Cleaning Grease off New Lathe Bed

Hey All

My back is killing me but I finally have my Laguna Revo 18/36 220v assembled and my garage wired properly.

The only issue is that the lathe bed has a lot of factory grease left on it and I think I should clean it before turning any wood.

My question is, what should I use to clean the lathe bed? I was thinking of using Denatured Alcohol, but I’m not sure. Any advise is appreciated.


“Pen Turning on the Rock”
NewfoundlandLaw is offline   Reply With Quote Top