International Association of Penturners - View Single Post - Finishing brown mallee
View Single Post
Old 03-16-2018, 07:06 AM   #29 (permalink)
PatrickR
 
Join Date: Apr 2017
Location: Zionsville, IN
Posts: 482
Photos: 0

Default Finishing brown mallee

Definitely an adhesion issue. One of the following.

Contamination (clean the blank with da between sanding grits and before finishing, allow to dry fully before using CA)

Bad CA (replace it)

Wood not fully dry or reached equilibrium for your climate before you started (weigh the blank when you get it, check it periodically)

Sanding too fine before finishing (polished wood has no tooth to hold the finish)

Good luck with the next one.

Last edited by PatrickR; 03-16-2018 at 07:20 AM.
PatrickR is offline   Reply With Quote Top