International Association of Penturners - View Single Post - Celtic Knot
Thread: Celtic Knot
View Single Post
Old 01-11-2018, 05:44 PM   #5 (permalink)
stevemorris
 
stevemorris's Avatar
 
Join Date: Oct 2014
Location: ontario
Posts: 18
Photos: 0

Default

its just the angle of the pic!!

pretty simple really, a fairly precise square piece of wood(7/8 sq) and some shop cut veneer, thickness depends on the bandsaw kerf

here's my bandsaw sliding table and a dial guage for the tablesaw to cut the veneer

the sled for the bandsaw cuts stopped kerfs with a stop to ensure they are all the same

my bandsaw kerf is a hair under 1/32, my tablesaw blade is 3/32, so I move the fence each time 0.120 inches for a piece that almost slides right in the kerf. a little sanding makes it fit

yeah, both my tablesaw and bandsaw are older than most of us here, so is my lathe.
Attached Thumbnails
dsc01274.jpg   dsc01276.jpg  
Likes: (1)
stevemorris is offline   Reply With Quote Top