International Association of Penturners - View Single Post - Furniture design question
View Single Post
Old 12-07-2017, 06:05 PM   #10 (permalink)
Charlie_W
 
Charlie_W's Avatar
 
Join Date: Nov 2011
Location: Sterling, VA USA
Posts: 4,306
Photos: 3

Default

Very nice job on the table!

One thought is that since the legs are not square, taper only the outer surface of each leg. How about a gradual taper from just below the skirt/apron to the floor....outer side only ending with the leg being square at the bottom? THe taper would lead the eye up the leg to the table top and the leg would not look as heavy.

I am not sure of a 45 degree chamfer on the bottom as it may look lost.

Good luck!
__________________
Charlie W.
Charlie_W is offline   Reply With Quote Top