International Association of Penturners - View Single Post - Furniture design question
View Single Post
Old 12-06-2017, 07:36 PM   #1 (permalink)
Dale Allen
Join Date: Oct 2012
Location: Akron, OH
Posts: 1,197
Photos: 0

Default Furniture design question

Any furniture designers out there?
Or anyone's opinion is accepted.
I am about half way through this octagon table and cannot decide about the bottom of the legs. I was thinking of tapering them at the bottom below the cross supports. It is about 3" to the floor and I was thinking of tapering them outward about 1".
Or maybe just taper all 4 side slightly as in about a 1/2" 45 degree bevel.
This will get a plywood bottom and a plexiglass top that will be removable.
I plan to use it as a table and a display case. Maybe even put some lights inside.
Thanks for looking and commenting.

Attached Thumbnails

Dale Allen is offline   Reply With Quote Top