International Association of Penturners - View Single Post - Hole too large
Thread: Hole too large
View Single Post
Old 11-06-2017, 08:21 AM   #17 (permalink)
Woodchipper
 
Woodchipper's Avatar
 
Join Date: Mar 2017
Location: Cleveland, TN
Posts: 1,370
Photos: 1

Default

Quote:
The lathe is not aligned perfectly, probably nothing you can do to the lathe, I always make mine a little longer and insert the tube from the exit end and remove the excess blank from the entrance end.
I would still have a big gap between the blank and the tube. I can see down in the blank and it would require a lot of CA to fill it. I'm thinking of going to Two Ton Epoxy that I used for installing fishing rod grips. It's thick and shouldn't run like thick CA.
__________________
Due to the lack of interest, tomorrow will be cancelled.
Likes: (2)
Woodchipper is offline   Reply With Quote Top