International Association of Penturners - View Single Post - Hole too large
Thread: Hole too large
View Single Post
Old 11-05-2017, 09:27 PM   #11 (permalink)
BURLMAN's Avatar
Join Date: May 2011
Location: Chattanooga, TN
Posts: 1,265
Photos: 10


I drill (bore) my blanks on my Shopsmith using a PSI pen blank chuck. Using the same drill bit and technique, with square blanks, I can have a centered hole one time, and the very next blank will be off center. Or vice versa. Can't figure it out, but suspect it its something I am doing.
BURLMAN is offline   Reply With Quote Top