International Association of Penturners - View Single Post - WTF!?!?!
Thread: WTF!?!?!
View Single Post
Old 10-12-2017, 09:51 AM   #3 (permalink)
BeeAMaker's Avatar
Join Date: Jan 2017
Location: Elkhart IN, USA
Posts: 573
Photos: 0


Originally Posted by tomtedesco View Post
Was there some heat source near the container? I would message Curtis to get his opinion.
No heat source. Although the containers inside felt slightly warm. Chemical reaction is all I can think of.

Wood showed 0 - 9% moisture max. So shouldn't have been an issue.

I set the Vac on last Friday. They have sat at almost -30m from Friday to Wednesday I was going to release the Vac today, top off any canisters that needed it and then re-vac for a couple more days but I found this. If it was moisture it seems that it would have shown sooner. I have had moisture before but was sure to check the level in the wood this time before proceeding. But still the moisture I have had before never caused this.
When you speak, you repeat what you already know. When you listen you learn...

Get the Pressure Pot Caddy!
Vertical Casting System
The MakerHive

BeeAMaker is offline   Reply With Quote Top