International Association of Penturners - View Single Post - Drilling Holes in Blanks
View Single Post
Old 08-12-2017, 06:24 PM   #6 (permalink)
Marmotjr
 
Marmotjr's Avatar
 
Join Date: Jun 2016
Location: Rome, Ohio
Posts: 215
Photos: 0

Default

Some Tailstocks have an eject feature, where as mentioned above, if the quill is far enough enough, it will push any MT2 item out of the quill. Extend your quill.

Also, wipe off the chuck taper, and blow out and wipe out the quill. If you get small debris in the taper, it won't seat properly, and will rattle free.

Check both the male and female tapers for defects, if there is some, it might be affecting the alignment or not letting it seat properly.
__________________
The only true way to get a correct response on the internet, is to post an incorrect one yourself. Hence why I post a lot.
Marmotjr is offline   Reply With Quote Top