International Association of Penturners - View Single Post - Drilling Holes in Blanks
View Single Post
Old 08-12-2017, 12:11 PM   #3 (permalink)
duncsuss
 
duncsuss's Avatar
 
Join Date: Jun 2012
Location: Wilmington, MA
Posts: 1,199
Photos: 1

Default

Tighten the handle to prevent the quill in the tailstock moving forwards/backwards. Can you wobble the drill chuck now?

YES => the drill chuck is not seated properly or it is defective

NO => everything is fine, loosen the quill lock just enough to allow you to turn the handle that advances the quill. Nearly all quills rattle around a bit when they that handle is fully loosened.
__________________
Duncan Suss
website: FruitOfTheLathe | facebook: FruitOfTheLathe

Likes: (2)
duncsuss is offline   Reply With Quote Top
Advertisement