Chriscb
Member
Evening,
Can some one who has oodles of knowledge about lasers please shed some light on an irksome problem I have with a Xtool D1 laser.
I'm using the most upto date D1 firmware, and software - both Lightburn (v1 1 04) and Laserbox (v1.2.0). The problem is that on burning a simple design on to a round cylinder (wood) the text is skewed but a straight line with text isn't. Burning the same file from Laserbox doesn't result in a skewed image. Am I correct in thinking that this points to a Lightburn/D1 interpretation problem? Just for completeness the settings were 300/20, single pass. The rotary settings were 32mm / rotation with 17mm roller diameter.
Burning flat images are fine - a 100mm square is square and a 100mm circle is round.
So the question is what can I do to correct the issue?
The images show the skewed text in a square, a single letter on a straight line and finally the image from Laserbox.
Any thoughts?
Thanks.
Regards,
Chriscb.
Can some one who has oodles of knowledge about lasers please shed some light on an irksome problem I have with a Xtool D1 laser.
I'm using the most upto date D1 firmware, and software - both Lightburn (v1 1 04) and Laserbox (v1.2.0). The problem is that on burning a simple design on to a round cylinder (wood) the text is skewed but a straight line with text isn't. Burning the same file from Laserbox doesn't result in a skewed image. Am I correct in thinking that this points to a Lightburn/D1 interpretation problem? Just for completeness the settings were 300/20, single pass. The rotary settings were 32mm / rotation with 17mm roller diameter.
Burning flat images are fine - a 100mm square is square and a 100mm circle is round.
So the question is what can I do to correct the issue?
The images show the skewed text in a square, a single letter on a straight line and finally the image from Laserbox.
Any thoughts?
Thanks.
Regards,
Chriscb.